5/26/2023 0 Comments Jlcpcb altium![]() Since different clients will use different software to design the board, and the software we process the Gerber data is also not the same as the software used for designing, so sometimes the software incompatibility problem arises. If there is no any note about it, then we will make it with the normal process. If there is any edge plating needed, or any plated slots are needed, please make sure that is not longer than 6 mm, and make a note about it when you place your order, or we can not make it for you. ![]() If there are both PCB files and GERBER files in your zip file, we will follow the Gerber file and ignore the PCB file.Ĥ. PCB file and GERBER file in the zip file at the same time So please make sure that the correct parameters are chosen and all those needed are converted into your Gerber file when you place your order. If any important, please kindly add it to the remark field when you place your order.ģ. ![]() The English descriptions and other statements in your zip file, such as some PDF files, DXF files, excel, etc., will be ignored and the PCB will be done according to the Gerber file provided only. The English descriptions and other attachments in the zip file To do solder-resistance bridges, usually, the spacing between the pads /pins needs to be 0.254 mm at least, and special notes are required when ordering such as : solder mask bridge is required. Or it will be ignored easily.Ģ. In order to avoid unnecessary trouble, please read those instructions carefully when ordering. It contains some routine internal operations JLCPCB will make when we receive the order. This description is aiming at explaining some confusion that our users have during placing the orders and some frequent problems they encountered in the past.
0 Comments
Leave a Reply. |